XK (X150) V8-4.2L (2008)
7. Release the subwoofer speaker housing.
-
Remove the 2 nuts.
-
Remove the 2 bolts.
-
Remove both speaker housing support brackets.
8. Remove the subwoofer speaker housing.
-
Carefully disconnect the MOST connector.
-
Disconnect the 3 electrical connectors.
CAUTION: Cover fibre optic cable connectors to minimize dust ingress and avoid bending the cables in a radius of less than 30 mm.
Installation
1. Install the subwoofer speaker housing.
-
Install the brackets.
-
Install the screws.
-
Tighten the nuts to 5 Nm (4 lb.ft).
-
Tighten the bolts to 10 Nm (7 lb.ft).
2. Connect the subwoofer speaker housing electrical connectors.
-
Connect the MOST connector.
3. Install the amplifier.
4. Install the subwoofer.
-
Connect the electrical connectors.
-
Install the screws.
5. Install the subwoofer cover.
-
Tighten the bolts to 10 Nm (7 lb.ft).
6. Install the carpet.
CAUTION: Make sure the carpet is correctly installed and that no foul-condition exists when the accelerator pedal is depressed.
7. Install the heater duct.
-
Install the Torx screws.
-
Install the lamp holder.
8. Install the instrument panel assembly.