XK (X150) V8-4.2L (2008)
> Remove the 4 screws.
> Release the electrical harness clip.
Installation
1. Install the brake pedal bracket.
> Align to the studs and lightly tighten the nuts.
> Install and tighten the bulkhead screws.
> Apply sealant to the bulkhead screw heads.
> Secure the electrical harness with the clip.
2. Tighten the brake pedal bracket nuts to 25 Nm (18 lb.ft).
3. Install the plenum chamber panel.
> Connect the washer jet hose.
> Carefully secure the clips.
4. Install the brake master cylinder cover.
> Carefully secure the clips.
5. Install the air intake cover.
> Carefully secure the clips.
6. Secure the brake booster.
> Tighten the nuts to 25 Nm (18 lb.ft).
> Install the brake pedal clevis pin.
7. Install the brake switch.
8. Install the throttle pedal assembly.
> Connect the electrical connector.
> Install the Torx screws.
9. Install the windshield wiper arms.
10. Install the instrument panel.
11. Connect the battery ground cable and install the cover.