XK (X150) V8-4.2L (2008)
8. Remove the fuel level sender unit.
-
Carefully release the 2 clips.
NOTE: Do not disassemble further if the component is removed for access only.
Installation
1. Install the fuel level sender unit.
2. Install the fuel pump module.
-
Connect the hoses.
-
Connect and secure the electrical connector.
WARNING:
-
The fuel tank is manufactured from stainless steel. Hand and arm protection must be used when removing parts from the inside of the
tank, to prevent any injury.
-
Wash hands thoroughly after fuel handling, as prolonged contact may cause irritation. Should irritation develop, seek medical
attention.
3. Install the new O-ring seals.
-
Clean the components mating faces.
4. Install the fuel pump and sender cover.
-
Disconnect the electrical connector.
-
Disconnect the 2 fuel lines.
5. Install the fuel pump and sender cover locking ring.
-
Tighten the nut to 10 Nm (7 lb.ft).
6. With assistance, install the fuel tank.
7. Connect the battery ground cable and install the cover.