XKR Convertible (X100) V8-4.0L SC (AJ27) (2001)
10. Fit both tie-rod-ends to steering arms.
-
Insert tie-rod-end taper pin into steering arm.
-
Fit and tighten nut.
-
Repeat procedure to fit opposite-side, tie-rod-end.
11. CAUTION: To prevent damage to the crossbeam, place a piece of wood between the transmission jack and crossbeam.
With assistance, position crossbeam on jack, and align crossbeam to vehicle.
12. Secure crossbeam rear mountings to chassis.
-
Fit and tighten mounting center bolt
-
Repeat procedure to secure opposite-side rear mounting.
13. Fit shock absorbers to lower mountings.
1. Align shock absorber to mounting and fit bolt.
2. Fit and tighten nut.
-
Repeat procedure to fit opposite-side shock absorber.
14. Fit front engine mounting bolts, but DO NOT tighten at this stage.
-
Repeat procedure on opposite-side mounting.