XKR Convertible (X100) V8-4.0L SC (AJ27) (2001)
1. Remove the tread plate.
NOTE: The finisher can be easily damaged, extra care must therefore be exercised during removal.
1. Using a thin plastic lever, carefully remove the treadplate finisher and place face uppermost on sheet of clean dry polythene.
2. Slacken and remove treadplate securing screws and remove treadplate.
3. Remove front of draught welt from aperture flange.
2. Exercising care to avoid damaging surface, pull pad rearwards to release retainer from 'A' post stud. On driver side it will be necessary to pull and
hold hood release rearwards.
3. Withdraw trim pad front tang from toeboard and remove trim pad.
Installation
1. Position trim pad at 'A' post and engage retainer on securing stud. For access at driver side it will be necessary to pull and hold hood release lever