XKR Convertible (X100) V8-4.0L SC (AJ27) (2001)
8.
Disconnect 'B' post occupancy sensor electrical connector.
9.
Pass seat belt anchor plates through rear quarter casing apertures and remove casing from vehicle.
Installation
1. Position rear quarter casing and engage two dowels in rear seat squab panel.
2. Pass seat belt anchor plates through casing apertures.
3. Connect 'B' post passenger restraint sensor electrical connector.
4. Press home and fully seat the remaining casing clips in body locations.
5. Position and seat front seat belt escutcheon to casing aperture.