XKR Convertible (X100) V8-4.0L SC (AJ27) (2001)
/v8-4.0l_sc_(aj27)/Page-907007.png)
4. Position cover on frame, aligning tape with tack strip centreline.
5. NOTE: It may be necessary to use a suitably soft drift and mallet to fully seat cover in tack strip.
Fit and fully seat rear edge of cover in tack strip retaining flange.
6. Using a suitable pointed tool pierce cover through existing holes in tack strip, drill through penetrations and pop rivet cover to tack strip.
7. Fit end covers to tack strip.
8. Position tack strip on BIW and commencing in centre fit and tighten securing bolts.
