XKR Convertible (X100) V8-4.0L SC (AJ27) (2001)
21. Support the latch assembly and loosen but do not remove the retaining bolts installed in the rear slotted holes. (Figure 12)
22. Lower the latch assembly.
23. Mark the hydraulic hoses with locations and disconnect the hoses from the cylinder assembly. (Figure 13)
24. Remove the latch assembly.
25. Install suitable blanking plugs to the convertible top latch cylinder and hydraulic hoses.
26. Remove the tie strap retaining hydraulic hoses to the latch assembly. (Figure 14)
27. Remove and discard the cloth tape retaining the hydraulic hoses to the A-pillar at the top edge of the instrument panel.
28. Detach the hoses from retaining clips in left-hand fuse box (CJB) opening. (Figure 15)