XKR Convertible (X100) V8-4.0L SC (AJ27) (2001)
3. Secure switch harness with suitable tape.
4. Fit cover to latch assembly.
-
Position cover over latch assembly, ensuring that internal boss locates correctly in latch housing.
-
Fit and tighten cover securing screw.
5. Fit latch assembly to door.
6. Connect ground cable to battery terminal and fit battery cover.
Door Window Control Switch Finish Panel
Door Window Control Switch Finish Panel (76.47.33)
Removal
1. Remove battery cover and disconnect ground cable from battery terminal.
2. Remove glass lift switch.
1. Remove glass lift switch end cover trim pad.
2. Remove the switch securing screw.
3. Disconnect the switch harness multiplug.
4. Release veneer panel clips.
Installation
1. Install veneer panel on switch ensuring retaining clips are fully seated.
2. Connect harness multiplug to switch.
3. Install glass lift switch.