XKR Convertible (X100) V8-4.0L SC (AJ27) (2001)
/v8-4.0l_sc_(aj27)/Page-1033002.png)
7. Remove quarter glass outer seal carrier.
-
Remove screws.
-
Remove seal carrier from vehicle.
8. Disconnect lift motor link lead from rear harness multiplug.
9. If earlier PVC water shedder is installed, route glass lift motor link lead through penetration and remove water shedder from body.
10. Connect a switched 12 volt supply to motor link lead connector and power glass to fully raised position.
11. Switch off 12 volt supply and disconnect from motor connector.
12. Remove three nuts securing glass lift motor/regulator assembly to body.
