Cherokee 4WD V6-173 2.8L VIN W 2-bbl (1985)
7. Remove the inboard brake pad and the antirattle clip (3).
CAUTION: Do not use compressed air to clean the outside of the caliper casting. Use a clean, dry shop towel and wipe the outside without
disturbing the dust boot.
WARNING: If the caliper has indications of leakage, overhaul it (refer to Brake Caliper/Service and Repair/Rebuild). See: Disassembly
and Assembly
Abutment Surfaces
8. Clean the abutment surfaces (5) of the anchor plate and caliper with a wire brush or crocus cloth.
Installation
For additional information see Installation Notes. See: Fundamentals and Basics
Outer Pad And Anti-Rattle Clip
INSTALLATION
1. Install the anti-rattle clip (3) on the trailing end of the anchor plate. The split end of the clip must face away from the rotor.
2. Position the inboard and outboard brake pads (4) in place while holding the clip (3).
CAUTION: Protect the caliper dust boot during caliper installation. A damaged boot can cause eventual piston seizure.