Commander 2WD V6-3.7L VIN K (2006)
Valve Body: Service and Repair
Installation
UNIT-ELECTROHYDRAULIC
INSTALLATION
1. Position the electrohydraulic unit in the transmission housing.
2. Insert selector valve (1) in driver of detent plate (2). When installing the electrohydraulic control module in the transmission housing, the plastic
part of the selector valve (1) must engage in the driver of the detent plate (2).
3. Install the Torx socket bolts (3) and torque to 8 Nm (71 inch lbs.).
4. Install a new oil filter (4).
5. Install oil pan (5) and torque the oil pan bolts to 8 Nm (71 inch lbs.).
6. Install the adapter plug (10) into the transmission housing and tighten the bolt (9) to 2.5 Nm (22 inch lbs.).
