Commander 2WD V8-4.7L Flex Fuel (2009)
1. Position power liftgate latch (3) into position on the liftgate (1).
2. Install screws (2) attaching latch to liftgate. Tighten screws to 17 Nm (150 in. lbs.) torque.
3. Connect wire connectors (2) to liftgate latch (3).
4. Engage outside handle link (1) into the clip on latch (3).
5. Verify liftgate fit and operation. Adjust as necessary, See: Adjustments/Liftgate - Adjustments.
6. Install the liftgate lower trim panel, See: Trunk / Liftgate Interior Trim Panel/Service and Repair/Liftgate Trim Panel - Installation.
Latch - Removal
REMOVAL
