Commander 2WD V8-4.7L Flex Fuel (2009)
added to the refrigerant systemSee: Service and Repair/Refrigerant Oil Level .
NOTE: If the rear A/C evaporator is being replaced, add 30 milliliters (1 fluid ounce) of refrigerant oil to the refrigerant system. Use only
refrigerant oil of the type recommended for the A/C compressor in the vehicle.
1. Install the blend-air door (1) and the mode-air door (4) onto the pivots located in the inboard half of the rear HVAC housing (3).
2. Install the rear A/C evaporator (2) into the inboard half of the rear HVAC housing.
3. Align the pivot shafts of the blend-air door and the mode-air door to the pivot holes located in the outboard half of the rear HVAC housing and
install the two halves of the rear housing (3) together. Make sure the three plastic retaining tabs (1) are fully engaged.
4. Install the 15 screws (2) and three metal clips (4) that secure the two halves of the rear HVAC housing together. Tighten the screws to 2 Nm (17
in. lbs.).