Commander 2WD V8-4.7L Flex Fuel (2009)
5. Install the rear blend door actuator (6) and the rear mode door actuator (4) to the rear HVAC housing (5) See: Air Door/Air Door Actuator /
Motor/Service and Repair/Blend Door Actuator - Installation and See: Air Door/Air Door Actuator / Motor/Service and Repair/Mode Door
Actuator - Installation.
6. Install the rear blower motor (2) .
7. Install the rear blower motor resistor (1) .
8. Install the rear HVAC wire harness (3) onto the rear HVAC housing and connect it to the rear blower motor resistor, rear blower motor, rear blend
door actuator and the rear mode door actuator. Make sure the harness is routed through all wiring retainers.
9. Position the flange (5) onto the bottom of the rear HVAC housing (3). Make sure that the evaporator drain is clean and unrestricted.
10. Install the four screws (4) and four clips (2) that secure the flange to the bottom of the rear HVAC housing. Tighten the screws to 2 Nm (17 in.
lbs.).
11. If removed, install the rear A/C expansion valve (1) onto the rear A/C evaporator See: Expansion Valve/Service and Repair/A/C Expansion Valve
- Installation.
