Commander 2WD V8-4.7L Flex Fuel (2009)
1. Position the upper suspension arm (2) in the frame rail bracket.
2. Install the mounting bolt (7) and nut (1) tighten to 129 Nm (95 ft. lbs.).
3. Position the upper suspension arm (4) in the axle bracket.
4. Install the mounting bolt (3) and nut (2) tighten to 136 Nm (100 ft. lbs.).
5. Raise the fuel tank back into place and secure See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service and
Repair/Removal and Replacement/Fuel Tank - Installation.
6. Remove the supports and lower the vehicle.
Right Side
RIGHT SIDE
NOTE: All torques should be done with vehicle on the ground with full vehicle weight.