Commander 4WD V8-4.7L Flex Fuel (2009)
Vanity Lamp: Service and Repair
Vanity Lamp - Removal
REMOVAL
NOTE: Vehicles equipped with optional vanity lamps have a single lamp above a covered mirror that is integral to each sun visor. Each lamp
is independently controlled by an integral switch that is automatically actuated by the mirror cover. The bulb types and service
procedures are identical for both of these lamps.
1. Disconnect and isolate the battery negative cable.
2. Using a small flat-bladed screwdriver, gently pry the upper edge of the lens (3) away from the vanity lamp housing far enough to disengage the
two snap features (1).
3. Pull the upper edge of the lens away from the visor far enough to disengage the two tabs (2) at the bottom of the lens from the lamp housing.
4. Carefully unsnap the bulb (2) from the two bulb holders (1) within the lamp housing.
5. Remove the bulb from the lamp.
