Commander 4WD V8-4.7L Flex Fuel (2009)
Vanity Lamp: Service and Repair
Vanity Lamp - Installation
INSTALLATION
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: Vehicles equipped with optional vanity lamps have a single lamp above a covered mirror that is integral to each sun visor. Each lamp
is independently controlled by an integral switch that is automatically actuated by the mirror cover. The bulb types and service
procedures are identical for both of these lamps.
1. Align the ends of the bulb (2) with the two bulb holders (1) within the vanity lamp housing.
2. Carefully press the bulb firmly and evenly into the bulb holders until it snaps into place.
3. Engage the two tabs (2) on the lower edge of the lens (3) within the bottom of the lamp housing.
4. Using hand pressure, press the upper edge of the lens over the top of the lamp housing until the two tabs (1) at the top of the lens snap into place.
5. Reconnect the battery negative cable.
