Commander 4WD V8-4.7L VIN N (2006)
Trunk / Liftgate Hinge: Service and Repair
HINGE
NOTE: It is not necessary to remove the liftgate to replace one or both hinges. The hinges can be replaced one at a time.
REMOVAL
1. Open and support the liftgate with a suitable prop or block.
2. Remove the liftgate support struts.
3. Using a trim stick C-4755 or equivalent, release the retaining clips that secure the header trim molding in the liftgate opening and remove.
4. Mark the hinge (1) liftgate half location on the lift-gate inner panel to aid reinstallation.
5. Remove the two screws (2) that secure the hinge to the liftgate.
