Commander 4WD V8-4.7L VIN N (2006)
6. Mark the hinge body half location on the upper lift-gate opening header to aid reinstallation.
7. Carefully pull the rear edge of the headliner downward from the header far enough to access and remove the two nuts (3) and one bolt (2) that
secure the hinge to the underside of the header.
8. Remove the hinge from the vehicle.
INSTALLATION
NOTE: Use a suitable body sealer on the hinge to body mating surfaces prior to installation.
1. Position the body half of the liftgate hinge (1) to the upper liftgate opening header on the vehicle.
2. Carefully pull the rear edge of the headliner downward from the header far enough to install and tighten the two nuts (3) and one bolt (1) that
secure the hinge to the underside of the header.
3. Tighten the fasteners to 28 N.m (21 ft.lbs).
