Commander 4WD V8-4.7L VIN N (2006)
1.
Trim 8 mm (5/16 in.) of material from the tip of the new cap. This will create a drain hole in the cap (Fig. 1).
2.
Remove the front door sill scuff plate.
3.
Remove the lower A-Pillar cowl (kick) panel. Refer to the detailed service information available in TechCONNECT, under: Service Info > 23 -
Body > Interior > Cowl Trim > Removal and Installation.
4.
Remove the molded end grommet of the sunroof front drain tube from the vehicle body.
5.
Slide the new modified cap over the molded end grommet of the drain tube (Fig. 2).
6.
Install the molded end grommet of the drain tube to the vehicle body.