Commander 4WD V8-4.7L VIN N (2006)
Sunroof / Moonroof Motor: Removal and Replacement
MOTOR/MODULE-SUNROOF
WARNING:
-
DO NOT ATTEMPT TO MOVE OR REPOSITION THE SUNROOF GLASS PANEL OR DRIVE CABLES WITH THE MOTOR/
MODULE REMOVED. VEHICLE/SUNROOF DAMAGE OR PERSONAL INJURY MAY RESULT.
-
THE SUNROOF MUST FIRST BE CALIBRATED AND THE MOTOR/MODULE INITIALIZATION PROCEDURE MUST BE
COMPLETED ANY TIME A SUNROOF MOTOR/MODULE IS REPLACED WITH A NEW COMPONENT. FAILURE TO
PERFORM THIS PROCEDURE COULD RESULT IN VEHICLE DAMAGE AND/OR PERSONAL INJURY.
REMOVAL
1. Disconnect the battery negative cable.
2. Remove the vehicle headliner.
3. Remove the power sunroof motor/module electrical connector (2).
4. Remove the retaining screws (3) and remove the motor/module (1) from the vehicle.
INSTALLATION
1. Position the power sunroof motor/module (1) in the vehicle.
2. Install the motor/module retaining screws (3). Tighten the screws to 4 N.m (35 in. lbs.).
3. Connect the motor/module electrical connector (2).
4. Partially install the vehicle headliner and connect all remaining sunroof electrical connectors.
5. Connect the battery negative cable.
6. Perform the sunroof position calibration. See: Testing and Inspection/Programming and Relearning/Sunroof Position Calibration
7. Perform the Motor/Module Initialization Procedure. See: Procedures/Initialization
8. Complete the vehicle headliner installation.
