Commander 4WD V8-4.7L VIN N (2006)
2. Install the fasteners (1) holding the motor to the seat adjuster (2). Tighten the screws to 5 N.m (44 in. lbs.).
3. Connect the motor electrical connector.
4. Install the seat cushion.
5. Clip the wire harness to cushion pan.
6. Install the seat assembly.
7. Connect the battery negative cable.
8. Verify normal operation of the power seat assembly.
HEIGHT ADJUST MOTOR
REMOVAL
WARNING: USE CAUTION WHEN REMOVING THE HEIGHT ADJUST MOTOR (3) IF THE MOTOR IS INOPERATIVE, AND THE
POWER SEAT IS NOT IN THE FULL UP POSITION. THE SEAT ADJUSTER ASSEMBLY (2) IS UNDER LOAD FROM THE HEIGHT
ADJUST SPRING AND MAY CAUSE THE MOTOR TO ROTATE UNDER PRESSURE WHEN THE FASTENERS ARE REMOVED. THE
SEAT ADJUSTER ASSEMBLY ALSO MAY SPRING UPWARD WHEN THE MOTOR IS REMOVED. IF THE HEIGHT ADJUST MOTOR
IS OPERATIVE, MOVE THE POWER SEAT TO THE FULL UP POSITION PRIOR TO DISCONNECTING THE BATTERY.
