Commander 4WD V8-4.7L VIN N (2006)
3. Remove Power Distribution Center (PDC) fasteners and set aside.
4. Remove battery tray assembly.
5. Remove washer bottle assembly.
6. Remove accessory drive belt.
7. Remove A/C compressor from mounting and set aside.
8. Remove A/C accumulator support bracket fastener.
9. Drain coolant.
10. Remove heater hoses at engine.
11. Remove fasteners attaching exhaust manifold heat shield.
12. Remove heat shield .
13. Remove upper exhaust manifold attaching fasteners.
14. Raise vehicle on hoist.
15. Disconnect exhaust pipe from manifold.
16. Remove fasteners attaching starter. Move starter aside.
17. Remove lower exhaust manifold attaching fasteners.
18. Remove exhaust manifold and gasket . Manifold is removed from below the engine compartment.
Installation
Installation
1. Install exhaust manifold and gasket from below engine compartment.
2. Install lower exhaust manifold fasteners (1,2,3,). DO NOT tighten until all fasteners are in place.
3. Lower vehicle and install upper exhaust manifold fasteners (1,2,3,). Tighten all manifold bolts starting at center and working outward to 25 Nm
(18 ft. lbs.).
CAUTION: Over tightening heat shield fasteners, may cause shield to distort and/or crack.
4. Install exhaust manifold heat shield. Tighten fasteners (4,5) to 8 Nm (72 in. lbs.), then loosen 45 degrees.
5. Install starter and fasteners.
6. Connect exhaust pipe to manifold.
7. Connect heater hoses at engine.
8. Install fastener attaching A/C accumulator.
9. Install A/C compressor and fasteners.
10. Install accessory drive belt.
11. Install washer bottle and battery tray assembly.
12. Install PDC.
13. Install battery and connect cables.
14. Fill cooling system.
