Commander 4WD V8-4.7L VIN N (2006)
1. Position the right front floor duct (5) and left front floor duct (6) into the vehicle
2. Connect the front floor ducts to the rear of the air distribution housing (4).
3. Install the instrument panel.
Rear Floor Ducts
DUCTS-FLOOR DISTRIBUTION
REAR FLOOR DUCTS
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING
WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE
THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO
DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE
AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY OR DEATH.
NOTE: LHD model shown in illustrations. RHD model similar.
1. Remove the floor console from the passenger compartment.
2. Remove the front seats.
3. Disengage the retainer (1) that secures the front console duct (2) to the gear selector (3).
4. Disconnect the front console duct from the air distribution housing (4) and remove the console duct.
5. Remove the screws (5) that secure the gear selector to the floor panel (6) and position the gear selector out of the way.
6. Roll back the front floor carpet from under the instrument panel toward the rear of the vehicle.
7. Disconnect the left rear floor duct (1) and the right rear floor duct (2) from the rear floor distribution duct (3).
