Commander 4WD V8-4.7L VIN N (2006)
8. Disengage the retainer that secures the rear floor ducts to the floor support and remove the floor ducts.
9. Disconnect the rear floor distribution duct from the air distribution housing (4) and remove the distribution duct.
INSTALLATION
1. Position the rear floor distribution duct (3) into the vehicle and connect it to the rear of the HVAC air distribution housing (4).
2. Position the left rear floor duct (1) and right rear floor duct (2) into the vehicle and engage the retainers that secure the floor ducts to the floor
support.
3. Connect the rear floor ducts to the rear floor distribution duct.
4. Install the carpet onto the front floor panel and under the instrument panel.
5. Position the gear selector (3) to its installed location on the floor panel (6) and securely install the retaining screws (5).
6. Connect the front console duct (2) to the air distribution housing (4) and engage the retainer (1) to the gear selector.
7. Install the front seats.
8. Install the floor console duct
9. Install the floor console.
Front Instrument Panel Duct
DUCT-INSTRUMENT PANEL
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING
WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE
THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO
DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE
AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY OR DEATH.
