Commander 4WD V8-4.7L VIN N (2006)
NOTE: LHD model shown in illustration with instrument panel removed for clarity. RHD model similar.
REMOVAL
1. Remove the floor console from the passenger compartment.
2. Disengage the retainer (1) that secures the front console duct (2) to the gear selector (3).
3. Disconnect the front console duct from the air distribution housing (4) and remove the console duct.
INSTALLATION
1. Position the floor console duct (2) into the vehicle.
2. Connect the front console duct to the air distribution housing (4) and engage the retainer (1) to the gear selector (3).
3. Install the floor console.
Front Air Outlets
OUTLETS-AIR
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING
WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE
THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO
DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE
AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY OR DEATH.
NOTE: Take the proper precautions to protect the front face of the instrument panel bezel from cosmetic damage while performing this procedure.
