Commander 4WD V8-4.7L VIN N (2006)
19.
Screw the bottle of cooling coil cleaner (p/n 05170022AA) onto the applicator tool.
20.
Connect the assembled applicator tool to the shop compressed air supply line.
21.
Insert the applicator tool into the blower resistor/power module opening.
22.
Spray all of the cooling coil cleaner onto the cooling coil continuously while moving the applicator tool up and down and back and forth so that
the evaporator is evenly covered until the required number of bottles are empty (See table for required number of bottles).
23.
Allow the vehicle sit for a minimum of 30 minutes.
24.
On LX/RS/**2005 WH/WK vehicles, raise the vehicle on a suitable hoist. On 2006 - 2007 WH/WK/XH/XK skip to step 27. Other vehicles
proceed to next step.**
CAUTION:
The excess cooling coil coating will drain when the cap/clamp/plug is removed in the next step.
25.
Remove the cap/clamp from the drain tube.
26.
On LX/RS/**2005 WH/WK** vehicles (other vehicles proceed to next step), lower the vehicle.
27.
Fill each empty cleaner bottle with normal tap water.
28.
One at a time, screw each bottle of water onto the applicator tool.
29.
Insert the applicator tool into the blower resistor opening.
30.
Spray the full contents of the water onto the evaporator continuously while moving the applicator tool up and down and back and forth so that the
evaporator is evenly covered with water.
31.
Install the blower motor resistor/power module.
32.
Start the engine.
33.
Raise all the windows to a slightly open position (about 1/2 inch opening).
34.
Set the blower to HIGH.
35.
Set the A/C switch to A/C OFF.
36.
Set mode switch to PANEL OUTLETS.
37.
Set temperature switch to FULL HEAT.
38.
Set recirculation switch to RECIRCULATE.
39.
Allow the blower to operate for 20 minutes.
40.
Turn the ignition switch to the OFF position.
41.
On LX/RS/**2005 WH/WK vehicles, raise the vehicle on a suitable hoist. On 2006 - 2007 WH/WK/XH/XK skip to step 44. Other vehicles
proceed to next step.**
42.
Cap/clamp off the drain tube using a suitable cap.
43.
On LX/RS/**2005 WH/WK/** vehicles (other vehicles proceed to next step), lower the vehicle.
CAUTION:
Technician must use eye protection, rubber gloves, protective clothing, and avoid breathing vapors.
44.
Open all windows in the vehicle.
45.
Remove the blower motor resistor/power module.
46.
Shake a 8 ounce bottle of Cooling Coil Coating (p/n 04728942AB), and screw the bottle onto the applicator tool.
