Commander 4WD V8-4.7L VIN N (2006)
rear blend door actuator (6) and remove the wire harness from the rear HVAC housing (5).
9. Remove the rear blower motor resistor.
10. Remove the rear blower motor.
11. Remove the rear mode door actuator and rear blend door actuator.
12. Remove the 15 screws (2) and three metal clips (4) that secure the two halves of the rear HVAC housing (3) together.
13. Release the three plastic retaining tabs (1) that secure the two halves of the rear HVAC housing together and separate the housing halves.
14. Carefully lift the rear A/C evaporator (2) out of the inboard half of the rear HVAC housing (3).
15. Remove the mode-air door (4) and blend-air door (1) from the inboard half of the rear HVAC housing. If the foam seal on any air-door is
deformed or damaged, the air door must be replaced.
ASSEMBLY
