Commander 4WD V8-4.7L VIN N (2006)
1. Install the blend-air door (1) and the mode-air door (4) onto the pivots located in the inboard half of the rear HVAC housing (3).
2. Install the rear A/C evaporator (2) into the inboard half of the rear HVAC housing.
3. Align the pivot shafts of the blend-air door and the mode-air door to the pivot holes located in the outboard half of the rear HVAC housing and
install the two halves of the rear housing (3) together. Make sure the three plastic retaining tabs (1) are fully engaged.
4. Install the 15 screws (2) and three metal clips (4) that secure the two halves of the rear HVAC housing together. Tighten the screws to 2 N.m (17
in. lbs.).
