Commander 4WD V8-4.7L VIN N (2006)
5. Install the rear blend door actuator (6) and the rear mode door actuator (4) to the rear HVAC housing (5).
6. Install the rear blower motor (2).
7. Install the rear blower motor resistor (1).
8. Install the rear HVAC wire harness (3) onto the rear HVAC housing and connect it to the rear blower motor resistor, rear blower motor, rear blend
door actuator and the rear mode door actuator. Make sure the harness is routed through all wiring retainers
9. Position the flange (5) onto the bottom of the rear HVAC housing (3). Make sure that the evaporator drain is clean and unrestricted.
10. Install the four screws (4) and four clips (2) that secure the flange to the bottom of the rear HVAC housing. Tighten the screws to 2 N.m (17 in.
lbs.).
11. If removed, install the rear A/C expansion valve (1) onto the rear A/C evaporator.
12. Install the rear heater core (2) into the end of the rear HVAC housing (3). Make sure that the foam seals are properly installed and that the two
retaining tabs (1) are fully engaged.
