Commander 4WD V8-4.7L VIN N (2006)
12.
Select "PCM".
13.
Select "More Options".
14.
Select "ECU Flash".
15.
Select "Manage Files".
16.
Highlight downloaded flash file.
17.
Select "Copy to SM Device" and then follow the screen prompts.
18.
Disconnect the ethernet cable from the StarMOBILE scan tool.
19.
Turn off the StarMOBILE scan tool and then restart the scan tool.
NOTE:
The StarMOBILE scan tool must be shut down and restarted to unlock the flash.
20.
From the "System Status" screen press the "Exit" button.
21.
From the "Main Menu" select "Enter Standalone Diagnostic Mode" and press the select button.
22.
Select "ECU View" and press the select button.
23.
Highlight "PCM" and press the select button.
24.
Select "FLASH ECU" and press the select button.
25.
Compare the highlighted software part number with the software part number displayed at the top of the screen.
>
If the part numbers are the same, the module is up to date and reprogramming is not required. Continue to Step 28.
>
If the software part numbers are different, press the select button to reprogram the module.
26.
Verify the file number on the screen. If correct press the select button and follow the screen prompts.
27.
When the flash is complete, press the "OK" button.
28.
Clear any Diagnostic Trouble Codes (DTCs) as follows:
NOTE:
Due to the PCM programming procedure, DTC(s) may be set in other modules (TCM, ABS, BCM, MIC, WCM, etc.) within the vehicle, if so
equipped. Some DTC's may cause the MIL to illuminate.
a.
From the "Standalone Home" screen highlight "All DTC's" and then press the select button.
b.
Highlight "Clear All Stored" and then press the select button.
c.
Follow the screen prompts on the StarMOBILE screen.
29.
Turn the ignition key to the "OFF" position and remove the StarMOBILE unit, StarMOBILE cable, and battery charger from the vehicle.
30.
Continue with Section C to install the Authorized Modifications Label.
C. Install the Authorized Modification Label
1.
Type or print (with a ballpoint pen) the recall number, dealer code and date on the Authorized Modifications Label (Figure 1).
