Electronic Brake Control Module: Technical Service Bulletins (page 7 of 8)

Make

Jeep

Model

Commander 4WD

Engine

V8-4.7L VIN N

Year

2006

Section

Relays and Modules - Brakes and Traction Control › Electronic Brake Control Module

Relays and ModulesTechnical Service Bulletins · page 7 of 8

1. Install new seals between the ABM and HCU.
2. Install the ABM (1) to the HCU (2).

3. Install the 3 ABM (1) mounting bolts to the HCU (2) if removed tighten mounting bolts to 12 N.m (9 ft. lbs.).

4. Install the HCU (3) with bracket (5) to the vehicle and tighten the 2 mounting nuts.
5. Reconnect the HCU electrical connector (5).

Pinch or Ctrl + scroll to zoom. Double-tap to reset.

01 Diagnostics

The same page in: Commander 2WD V6-3.7L VIN K (2006), Commander 2WD V6-3.7L VIN K (2006), Commander 2WD V6-3.7L VIN K (2006), Commander 2WD V8-5.7L VIN 2 (2006), Commander 2WD V8-5.7L VIN 2 (2006), Commander 2WD V8-5.7L VIN 2 (2006), Commander 4WD V8-4.7L VIN N (2006), Commander 4WD V8-4.7L VIN N (2006).