Commander 4WD V8-4.7L VIN N (2006)
16.
Select "Close" after the download is complete, then select "Back".
17.
Highlight the listed calibration.
18.
Select "Update Controller". Follow on screen instructions.
19.
When the update is complete, select "OK".
20.
Verify the part number at the top of the "Flash FCM screen has updated to the new part number.
NOTE:
Due to the FCM programming procedure, a DTC may be set in other modules (PCM, ECM, TCM, BCM, MIC, SKREEM, etc.) within the
vehicle, if so equipped. Some DTC's may cause the MIL to illuminate. From the "Home" screen select "System View". Then select "All
DTCs". Press "Clear All Stored DTCs" if there are any DTCs shown on the list.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
