Commander 4WD V8-4.7L VIN N (2006)
Seat Belt: Service and Repair
Second Row Outboard
SEAT BELT AND RETRACTOR
SECOND ROW OUTBOARD
WARNING: TO AVOID PERSONAL INJURY OR DEATH, DURING AND FOLLOWING ANY SEAT BELT OR CHILD RESTRAINT
ANCHOR SERVICE, CAREFULLY INSPECT ALL SEAT BELTS, BUCKLES, MOUNTING HARDWARE, RETRACTORS, TETHER
STRAPS, AND ANCHORS FOR PROPER INSTALLATION, OPERATION, OR DAMAGE. REPLACE ANY BELT THAT IS CUT,
FRAYED, OR TORN. STRAIGHTEN ANY BELT THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS. REPLACE ANY BELT
THAT HAS A DAMAGED OR INOPERATIVE BUCKLE OR RETRACTOR. REPLACE ANY BELT THAT HAS A BENT OR DAMAGED
LATCH PLATE OR ANCHOR PLATE. REPLACE ANY CHILD RESTRAINT ANCHOR OR THE UNIT TO WHICH THE ANCHOR IS
INTEGRAL THAT HAS BEEN BENT OR DAMAGED. NEVER ATTEMPT TO REPAIR A SEAT BELT OR CHILD RESTRAINT
COMPONENT. ALWAYS REPLACE DAMAGED OR FAULTY SEAT BELT AND CHILD RESTRAINT COMPONENTS WITH THE
CORRECT, NEW AND UNUSED REPLACEMENT PARTS LISTED IN THE DAIMLERCHRYSLER MOPART PARTS CATALOG.
REMOVAL
1. Fold and tumble the second row outboard seat forward against the front seat for easiest access to the seat belt lower anchor and the C-pillar trim.
2. Loosen the screw (9) that secures the second row outboard seat belt lower anchor (6) and the seat latch striker bracket (8) to the rear floor panel.
3. Disengage the lower anchor from the loosened seat latch striker bracket screw.
4. Remove the upper trim (3) from the inside of the C-pillar.
5. Pull the second row seat belt (4) and lower anchor through the seat belt opening in the upper C-pillar trim.
6. Remove the trim from the quarter inner panel.
7. Remove the screw (11) that secures the seat belt turning loop (2) to the upper C-pillar (1).
8. Remove the seat belt turning loop from the upper C-pillar.
9. Remove the screw (5) that secures the retractor (7) to the lower C-pillar.
10. Disengage the retractor locator tab from the slot in the lower C-pillar.
11. Remove the second row outboard seat belt and retractor from the lower C-pillar as a unit.
INSTALLATION
