Commander 4WD V8-4.7L VIN N (2006)
1. Be certain that the retractor shield (1) is properly installed in the inner C-pillar and in good condition before installing the retractor.
2. Position the second row outboard seat belt (4) and retractor (7) to the lower C-pillar as a unit.
3. Engage the locator tab on the back of the retractor into the slot in the lower C-pillar.
4. Install and tighten the screw (5) that secures the retractor to the lower C-pillar. Tighten the screw to 39 N.m (29 ft. lbs.).
5. Position the seat belt turning loop (2) to the upper C-pillar (1). Be certain the seat belt webbing between the retractor and the turning loop is not
twisted.
6. Install and tighten the screw (11) that secures the seat belt turning loop to the upper C-pillar. Tighten the screw to 39 N.m (29 ft. lbs.).
7. Reinstall the trim onto the quarter inner panel.
8. Route the seat belt lower anchor (6) through the seat belt opening in the upper C-pillar trim (3).
9. Reinstall the trim onto the upper C-pillar.
10. Engage the seat belt lower anchor under the loosened screw (9) that secures the seat latch striker bracket (8) to the rear floor panel. Be certain the
seat belt webbing between the turning loop and the lower anchor is not twisted.
11. Tighten the screw that secures the lower anchor and the seat latch striker bracket to the rear floor panel. Tighten the screw to 50 N.m (37 ft. lbs.).
12. Restore the second row outboard seat to its seating position.
