Commander 4WD V8-4.7L VIN N (2006)
Seat Sensor/Switch: Service and Repair
Seat Track Position Sensor
SEAT TRACK POSITION SENSOR
WARNING: TO AVOID PERSONAL INJURY OR DEATH, ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE
SUPPLEMENTAL RESTRAINT SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, AIRBAG,
OCCUPANT CLASSIFICATION SYSTEM, SEAT BELT TENSIONER, IMPACT SENSOR, OR INSTRUMENT PANEL COMPONENT
DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO
MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS
THE ONLY SURE WAY TO DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER
PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT.
REMOVAL
1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
2. Reach under the front seat cushion to access the seat track position sensor (3) in a bracket (5) located on the inboard side of either the inner or
outer, driver or passenger seat track.
3. Disconnect the seat wire harness connector (4) from the sensor.
4. Remove the screw (1) that secures the sensor mounting boss to the bracket.
5. Using a small screwdriver, depress the sensor latch feature (2) and pull the sensor out of the bracket.
INSTALLATION
1. Reach under the front seat cushion to position the seat track position sensor (3) to the open end of the bracket (5) located on the inboard side of
either the inner or outer, driver or passenger seat track.
2. Push the sensor firmly into the bracket until the latch feature (2) snaps into place.
