Commander 4WD V8-4.7L VIN N (2006)
3. Install and tighten the screw (1) that secures the sensor mounting boss to the bracket. Tighten the screw to 2 N.m (15 in. lbs.).
4. Reconnect the seat wire harness connector (4) to the sensor connector receptacle located on the end of the sensor. Be certain that the latch on the
connector is fully engaged.
5. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
6. Following successful completion of the supplemental restraint system verification test procedure, perform the Occupant Classification System
Verification Test using a diagnostic scan tool. Refer to the appropriate diagnostic procedures.