Commander 4WD V8-4.7L VIN N (2006)
Battery Tray: Service and Repair
BATTERY TRAY
GAS ENGINE
REMOVAL
1. Remove the battery from the battery tray.
2. Remove the battery wire harness three pin connector (11) from the battery tray (12).
3. Remove the two screws (3) that secures the battery tray (4) to the inner fender and the bracket on the radiator support.
4. Remove the one screw (2) that secures the outboard side of the battery tray (4) to the left inner fender.
5. Remove the one nut (1) that secures the rear of the battery tray to the stud (5) on the front frame rail.
6. Remove the battery tray from the left front corner of the engine compartment.
INSTALLATION
