Commander 4WD V8-4.7L VIN N (2006)
8. Remove generator from vehicle.
INSTALLATION
1. Position generator (3) to engine and install 2 horizontal bolts (1) and 1 vertical bolt (2).
2. Tighten all 3 bolts to 40 ft. lbs. (55 N.m).
3. Snap field wire connector (4) into rear of generator.
4. Install B+ terminal eyelet to generator output stud. Tighten mounting nut (2) to 108 in. lbs. (12 N.m).
CAUTION:
-
Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
-
When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump may be rotating in the wrong direction
if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or refer to Belt Schematics
in Cooling System.
