Commander 4WD V8-4.7L VIN N (2006)
Voltage Regulator: Description and Operation
REGULATOR, VOLTAGE
DESCRIPTION
The Electronic Voltage Regulator (EVR) is not a separate component. It is actually a voltage regulating circuit located within the Powertrain Control
Module (PCM). The EVR is not serviced separately. If replacement is necessary, the PCM must be replaced.
OPERATION
The amount of DC current produced by the generator is controlled by EVR circuitry contained within the PCM. This circuitry is connected in series with
the generators second rotor field terminal and its ground.
Voltage is regulated by cycling the battery voltage to control the strength of the rotor magnetic field. The EVR circuitry monitors system line voltage
(B+) and battery temperature (refer to Battery Temperature Sensor). It then determines a target charging voltage. If sensed battery voltage is 0.5 volts or
lower than the target voltage, the PCM energizes the field winding until sensed battery voltage is 0.5 volts above target voltage. A circuit in the PCM
cycles the battery side of the generator field up to 100 times per second (100Hz), but has the capability to full field to achieve the target voltage. If the
charging rate cannot be monitored (limp-in), a duty cycle of 25% is used by the PCM in order to have some generator output.
