Commander 4WD V8-4.7L VIN N (2006)
Suspension Travel Bumper: Service and Repair
JOUNCE BUMPER/CUP
REMOVAL
1. Raise and support the vehicle. Position a hydraulic jack under the axle to support the axle.
2. Remove the wheel and tire assemblies.
3. Remove the lower shock bolt (3) from the axle bracket.
4. Remove the stabilizer bar link from the body rail.
5. Lower the hydraulic jack and tilt the axle and remove the coil spring (4).
6. Remove the jounce bumper (6) and cup (4).
INSTALLATION
1. Install the jounce bumper and cup, Tighten to 54 Nm (40 ft. lbs.).
2. Install the jounce bumper.
3. Install the upper isolator.
