Commander 4WD V8-4.7L VIN N (2006)
10. Remove the two screws (2) that secure the washer reservoir (1) to the left front frame rail.
11. Disengage the hook tab at the front of the washer reservoir from the slot in the left front frame rail.
12. Lower the washer reservoir from the vehicle, rotating it as necessary for clearance.
INSTALLATION
1. Position the washer reservoir (1) into the left front fender wheel house from underneath the vehicle.
2. Raise the washer reservoir into position, rotating it as necessary for clearance.
3. Engage the hook tab at the front of the reservoir into the slot in the left front frame rail.
4. Install and tighten the two screws (2) that secure the washer reservoir to the left front frame rail. Tighten the screws to 7 N.m (60 in. lbs.).
NOTE: Be certain to reconnect the front and rear washer hoses to the proper outlet nipples of the washer pump. Failure to properly connect the
hoses will cause the front and rear washer systems to operate incorrectly.
