Compass 4WD L4-2.4L VIN W (2007)
CAUTION: A strain gauge alignment tool (Special Tool No. 9689) (2) must be used to secure the body of the seat weight sensor (1) from
any rotation during removal or installation of the nut that secures the sensor stud to the seat cushion frame. In addition, the sensor
fasteners should always be serviced using hand tools ONLY, and not electric or pneumatic power tools. Failure to observe these cautions
may result in irreversible sensor damage requiring sensor replacement.
4. Install the strain gauge alignment tool (Special Tool 9689) on the sensors by inserting the center fork (1) of the tool between the flats on each side
of the sensor body and inside of the cage, then seating the tool support yoke (2) firmly against the outside of the sensor cage.
5. With the alignment tool securing the body of the seat weight sensor, install and tighten the nut that secures the sensor stud to the seat cushion
frame. Tighten the nut to 45 Nm (33 ft. lbs.).
6. Transfer the special tool to each weight sensor, one at a time, then install and tighten the nuts that secure each of the four sensor studs to the seat
cushion frame until all four nuts have been installed and tightened.
7. Reinstall the seat cushion onto the passenger side front seat.
8. From the underside of the seat, reconnect the seat wire harness to the connector receptacle of the seat track position sensor located on the inboard
side of the outboard seat adjuster upper track near the rear of the seat track.
9. Reconnect the seat wire harness to the connector receptacles of each of the four weight sensors.
10. Reinstall the passenger side front seat into the vehicle.
11. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
12. Following successful completion of the supplemental restraint system verification test procedure, perform the Occupant Classification System
Verification Test using a diagnostic scan tool and the Occupant Classification Seat Weight special tool. Refer to the appropriate diagnostic
procedures.
