![]() |
Jeep Workshop Manuals | |
Grand Cherokee 2WD V6-3.7L (2008)Maintenance > Brake Bleeding > System Information > Service and Repair > ABS Brake Bleeding > Page 2060![]() Brake Bleeding: Service and Repair MANUAL BLEEDING Use Mopar brake fluid, or an equivalent quality fluid meeting SAE J1703-F and DOT 3 standards only. Use fresh, clean fluid from a sealed container at Do not pump the brake pedal at any time while bleeding. Air in the system will be compressed into small bubbles that are distributed throughout the Do not allow the master cylinder to run out of fluid during bleed operations. An empty cylinder will allow additional air to be drawn into the system. Bleed only one brake component at a time in the following sequence: 1. Fill the master cylinder reservoir with brake fluid. reservoir once more before proceeding. 3. Attach one end of bleed hose to bleed screw and insert opposite end in glass container partially filled with brake fluid. Be sure end of bleed hose is immersed in fluid. 4. Open up bleeder, then have a helper press down the brake pedal. Once the pedal is down close the bleeder. Repeat bleeding until fluid stream is clear and free of bubbles. Then move to the next wheel. Maintenance > Brake Bleeding > System Information > Service and Repair > ABS Brake Bleeding > Page 2060 | ||
[PREV PAGE] [NEXT PAGE] |