Workshop Repair Manuals

Jeep Workshop Manuals

[PREV PAGE] [NEXT PAGE]

jeep Workshop Repair Guides


Grand Cherokee 2WD V6-3.7L (2008)

Powertrain Management > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Service and Repair > Engine Control Module (ECM)

Page 1
background image

Engine Control Module: Service and Repair
Engine Control Module (ECM)

Removal

REMOVAL

1. Remove the battery. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement/Battery - Removal
2. Remove the battery tray. See: Starting and Charging/Battery/Battery Tray/Service and Repair/Battery Tray - Removal

3. Disconnect Engine Control Module (ECM) electrical connectors (2).
4. Remove the two ECM hold down bolts (1).

5. Pull the ECM (1) from the bracket (3).
6. Remove the ECM from the vehicle.

Installation

INSTALLATION

NOTE: Any time a new injector is installed, or if an existing injector is installed in any location other than its original location, the injector
quantity adjustment procedure must be performed. 

Powertrain Management > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Service and Repair > Engine Control Module (ECM)

[PREV PAGE] [NEXT PAGE]