Liberty 4WD V6-3.7L (2009)
NOTE: To connect the ABM wiring connector to the ABM in the following step, begin with the release lever in the full upward (released)
position. Push the connector onto the ABM socket and rotate the release lever (2) downward until it snaps into place in the locked
position below the release tab (1).
4. Install ABM wiring connector (2) into socket of ABM.
5. Connect negative battery cable to battery post.
6. Hook up the scan tool to initialize the ABM and perform the following:
a. Clear any faults.
b. Perform the ABS Verification Test and road test the vehicle. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/ABS Verification Test
