Wagoneer L4-150 2.5L VIN E TBI (1990)
14.
Pull the brake hydraulic unit and mounting bracket forward until the bracket studs are clear of the dash panel. Tilt the inboard side of the
unit up to gain access to the ECU harness connector (Figure 7) and supply line clamp, (Figure 8).
15.
Disconnect the ECU harness from the pressure modulator, (Figure 8).
16.
Loosen the hose clamp and disconnect the supply line from the bottom of the reservoir, (Figure 8). Remove the hose from the clip on the
accumulator block.
17.
Lift the assembly up and out of the engine compartment and place it on a clean, dry bench.
Low Pressure Hose Replacement
