Wagoneer L6-242 4.0L VIN M FI (1988)
FIGURE 4
4.
Remove the existing starter relay mounting screws and the relay.
5.
Install the new starter relay (D - Fig. 3) supplied in the resistor kit using the previously removed mounting screws.
6.
Connect all previously marked leads to the new starter relay at the appropriate terminals.
NOTE:
No wire should be connected to the terminal marked F, on the new starter relay at this time.
7.
Attach terminal E (Fig. 3) of the new wire harness, orange w/tr and gray wires, to terminal F (Fig. 4) of the new starter relay.
FIGURE 5
8.
Remove the four relay holders from the fender bracket by squeezing the locking tabs on the fender side of the bracket.
9.
Separate the O(2) sensor heater relay (H - Fig. 5) and holder from the rest of the relays.