Wrangler L4-150 2.5L VIN H TBI (1986)
Push Rod: Service and Repair
Fig. 5 Rocker arm, bridge & pivot assembly
1.
Remove rocker arm cover attaching screws, then remove rocker arm cover as described under ``Cylinder Head, Replace.'' RTV sealant is used
between rocker arm cover and cylinder head mating surfaces. To avoid damaging rocker arm cover, do not pry cover upward until seal has been
completely broken. When prying cover upward, pry only in areas marked ``Pry Here,'' which are located near rocker arm cover bolt holes.
2.
Alternately loosen the rocker arm cap screws one turn at a time to prevent damage to bridge, Fig. 5.
3.
After removing rocker arm cap screws, remove bridge, pivots, rocker arms and pushrods. Tag all components so they can be reinstalled in the
same position as removed.
4.
Reverse procedure to install. When installing rocker arm cap screws, tighten each screw alternately and evenly approximately one turn at a time to
prevent damage to bridge.